Toyota
Corolla
E140/E150 [2006 - 2010]
Petrol
E140/E150 [2006 - 2010]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Clutch
Gearbox
Cardan Drive
Rear axle and front axle
Front-wheel drive
Other…
Add to garage Filter

Manual transmission oil change Toyota Corolla

print share bookmark_border
0 Views
0.0 Rating
Not indicated
Car services nearby

We buy oil in a box and take all the  inventory:

Head 24 - unscrew the drain and filler caps
Head 17 (if I am not mistaken) - unscrew the protection
Watering can
Hose ~ 50 cm
Oil - TOYOTA Gear Oil Manual Transmission LV 75W (0888581001) 2 liters.

Reasons  - they are not, replacement for the sake of prevention.

Note:

Difficulties - before twisting something, read the manuals! Considering himself the smartest, he dismantled the floor of the car in search of drain and filler plugs. It turned out to be much simpler.
You do not need to remove anything, except for the crankcase protection (who has it).

Manual transmission oil change Toyota Corolla

1. Place the vehicle on a pit or overpass.


2. We unscrew the crankcase protection nuts.


3. Fixing protection by 4 bolts.


4. In order not to get hit on the head with a sheet of iron, we put props under the crankcase protection in advance.


5. Filler bolt. Head 24 mm. Unscrew it counterclockwise. The head should not be long.


6. First, we check the initial level - it should be under the cut of the filler neck. The location of the filler bolt is located just below the clutch release foot, looks towards the coolant radiator.


7. Drain plug. The head is 24. We turn it counterclockwise. We rip off just a little bit, so as not to take a shower. Location - under the left wheel drive (in the direction of travel).


8. To drain and fill in more, we lift the front end.


9. Cut off the baklash and unscrew the drain bolt.


10. Drain bolt with sealing ring.


11. Adjust the body lift higher/lower to drain more.

12. We tighten the drain bolt (the one with the ring).


13. Go to prepare the watering can.


14. Hose length approx. 50 cm, outer diameter approx. 1.2 cm, inner diameter 0.6. You could have more, but I couldn't find another in the garage.


15. We fix the watering can.


16. Insert the opposite end of the hose into the gearbox filler hole.


17. Due to the small inner diameter of the hose, there is no throughput. Slowly but surely the level in the watering can fell.


18. Vbuhali 2 liters without a couple of drops with a poddamkracheny front end.


20. We twist the filler cap, wipe it with a cloth and put on the crankcase protection.


21. Old oil on the left, new on the right. There is no visual difference.

Source: https://www.drive2.ru/l/5937330/

favorite 0
print
share
bookmark_border
alino4karivne