- You will need: ruler, caliper, chalk (or wire) for marking, tape.
- With an increased free play of the steering wheel, it is difficult to control the car, as it responds to the driver's actions with a delay. In addition, an increased stroke that cannot be eliminated by adjusting the steering gear indicates a malfunction of the steering (weakening of the steering gear, steering rods or wear of their parts).
- The play must not exceed 9°. You can also determine the backlash in linear units (mm) by the formula L = (9 ° / 360 °)? D, where L is the steering wheel play, mm; ? = 3.14; D - outer diameter of the steering wheel, mm. The play must not exceed 30 mm.
- 1. Check steering wheel play with the vehicle on a level, non-slip surface. Set the front wheels to a straight ahead position.

- 2. Fix the ruler on the instrument panel so that its end touches the outer surface of the steering wheel rim.
- 3. Without changing the position of the ruler, turn the steering wheel to the right until the front wheels begin to turn

- 4. Mark the steering wheel rim in this position (attach the wire).
- 5. Without changing the position of the ruler, turn the steering wheel to the left until the front wheels begin to turn.

- 6. In this position, put a second mark on the steering wheel rim (fix the wire).

- 7. Measure the distance between the marks along the rim. It should not exceed the calculated value.
- 8. If the distance (steering wheel free play) is more than 30 mm, the cause must be found and corrected.
- Source: Hyundai Santa Fe Owner's Manual, Third Rome Publishing House
Removing and installing front bumper Hyundai Santa Fe CM 2006-2012
30 minutes - 1 hour
[[ article.getBookmarkIcon() ]]
Instrument
Removal and installation of a crossbar of a back suspension bracket Hyundai Santa Fe
[[ article.getBookmarkIcon() ]]
Instrument
Features of the Hyundai Santa Fe evaporative emission system device
[[ article.getBookmarkIcon() ]]
No tools
Checking the level, topping up and changing the oil in the transfer case Hyundai Santa Fe
[[ article.getBookmarkIcon() ]]
Instrument
Replacement of contact group of the switch (lock) of ignition Santa Fe CM 2006-2012
1 to 3 hours
[[ article.getBookmarkIcon() ]]
Instrument