Checking the level and adding oil to the lubrication system of the Nissan Qashqai engine

 Engine HR16DE or MR20DE

 K9K engine

 M9R engine

 normal range

 MIN Label

 MAX label

Caution: The engine oil level must be checked regularly, at least every time you fill up with fuel. Operating the engine with an insufficient oil level can result in engine failure. The factory warranty does not cover such cases of engine damage.

1. Park the vehicle on a level surface and apply the parking brake.

2. Start the engine. Warm up the engine at idle to normal operating temperature.

3. Stop the engine.

4. Wait at least 10 minutes for the oil to drain into the engine sump.

5. Open the hood.

6. Remove the control oil dipstick and wipe it dry.

• Models with M9R ​​engine: The engine oil dipstick is attached to the oil filler cap. Remove the engine oil filler cap and wipe the dipstick dry.

7. Fully insert the dipstick into place.

• Models with M9R ​​engine: Replace the engine oil filler cap.

8. Remove the dipstick again and check the oil level. The oil level must be in the range

9. If the oil level is below the MIN level, remove the filler cap and add the recommended engine oil to the engine. Do not add oil above the upper mark I.

10. Check the engine oil level again.

11. Replace the oil filler cap and tighten it securely.

12. Close the hood.

The engine will normally use some oil between changes, depending on the operating conditions and the characteristics of the oil being used. More oil is consumed during frequent acceleration and deceleration of the vehicle, and especially at high engine speeds. More frequent topping up of oil may also be required during the initial period of operation of a new engine. If after a run of 5000 km the oil consumption exceeds 0.5 liters per 1000 km, you need to contact a service station.

Source: http://automn.ru/nissan-qashqai/nissan-47409-10.m_id-6792.m_id2-6843.html