Hyundai
Santa Fe
CM [2006 - 2010]
Petrol
CM [2006 - 2010]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Clutch
Gearbox
Cardan Drive
Rear axle and front axle
Front-wheel drive
Other…
Add to garage Filter

Hyundai Santa Fe automatic transmission control cable adjustment and replacement

print share bookmark_border
0 Views
0.0 Rating
Tool
Not indicated
Period:
Total views:
Per year:
Per 30 days:
Per 7 days:
Today:
Duration of viewing:
Watching now:
0.0
Average rating
0votes
5
0
4
0
3
0
2
0
1
0
Rate article
Good (4 points)
Tool
A tool is required to perform operations
Not indicated
Average running time
0 votes

Car services nearby
  • You will need: screwdrivers with a flat and cross-shaped blade, pliers, a “10” key, a “12” socket head.
  • 1. To adjust the automatic transmission control cable, place the transmission control lever in the "N" position.
  • 2. Remove the battery and its mounting shelf.
  • 3. Loosen the nut securing the cable end to the range selector lever on the transmission control unit.
  • 4. Adjust the position of the end of the cable so that the end is in the middle position without tension and bends.
  • 5. Tighten the cable end nut.
  • 6. Install the removed parts in the reverse order of removal.
  • 7. Check up clearness of inclusion of modes of a transmission in all provisions of the lever of management of a transmission. Re-adjust if necessary.
  • 8. To replace the automatic transmission control cable, unscrew the nut securing the cable tip to the gearbox control unit lever.
  • 9. Pry off the bent edge of the spring retainer of the tip of the cable sheath ...
  • 10. ... and remove the retainer from the slot in the tip.
  • 11. Disconnect a tip from the lever and take out a tip from a bracket groove on a transmission.
  • 12. Remove the front seats (see "Removing and installing the front seat").
  • NOTE
  • With sufficient experience, it is possible to replace the automatic transmission control cable without removing the front seats.
  • 13. Remove the lining of the floor tunnel (see "Removing and installing the lining of the floor tunnel").
  • 14. Remove the cable end pin from the hole in the control lever.
  • 15. Disconnect the tip of the cable from the control lever.
  • 16. Press the latch ...
  • 17. ... and remove the cable from the hole in the body of the wings of the control lever.
  • 18. Under the instrument panel, unscrew the two nuts securing the cable bracket to the bulkhead and remove the cable into the passenger compartment, removing its tip through the hole in the bulkhead.
  • 19. Install the parts in the reverse order of removal.
  • Source: Hyundai Santa Fe Owner's Manual, Third Rome Publishing House
favorite 0
print
share
bookmark_border

Login or register


account_circle
vpn_key
account_circle
vpn_key
lock
Cancellation