Nissan Qashqai armrest repair

So, if your armrest creaks or falls off, you will need to remove:

- Rear armrest panel (plastic cover, which is obtained in the middle of the rear passengers). It is removed very simply - we go to the rear seats, from below, where the carpet is, we grab and pull.

Next, photo and description:

- Coasters (1). Open the armrest, take the cup holders, pull up one side, then the other.
It turns out a useful technological hole through which you can tighten the handbrake, hide something, or continue to disassemble the car.

- Round handle (2). In order not to pick anything, I snap off the latches from the inside. We stick our right hand into the hole of the removed coasters, and try to feel the latches of the round handle. The first (near row) is skipped. The ones we need are at the very round handle, left and right. We squeeze them and push them up.

— Selector frame (3). (It will be useful to comrades who DO NOT KNOW that the selector positions are highlighted. That is where the light bulb lives.) It is removed in the same way, just put our hand in, now into a new hole.
There are SIX pins. you can only get to 4. At the same time, you can test the dexterity of your fingers. Far two, especially do not resist.
Approximate location - in the picture above.

Next, tighten the handbrake, grab the panel and in places convenient for you, try to disconnect it. Perhaps the easiest will be at the base of the armrest.

Here is the source of the problem:

Tighten this screw and fix the problem.

Source: http://www.drive2.ru/l/6033592/