Mercedes-Benz
C-Класс
W203/S203/CL203 [2000 - 2004]
Petrol
W203/S203/CL203 [2000 - 2004]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Add to garage Filter

Removal and installation of the front wing Mercedes-Benz W203

print share bookmark_border
0 Views
0.0 Rating
Tool
Not indicated
Car services nearby

Tools:

  • Jack
  • Support legs
  • torque wrench

Parts and consumables:

  • Dye
  • plastic wedge
  • Bearing grease
  • Wheel bolts

Withdrawal

1. Mark with paint the position of the corresponding front wheel relative to the hub. This will allow the assembly to install the balanced wheel in its original position. Loosen the wheel bolts before jacking up the vehicle. Raise the front of the car, put it on stands and remove the front wheel.

Note:

The operation of lifting and placing the vehicle on stands is dangerous! Therefore, before carrying out the operation, read the Section  Jacking and Towing  of the Introduction to the manual.

2. Remove the front wing locker, refer to the appropriate section .

3. Turn out a lock bolt between a wing and a bumper.

4. Turn out bolts of fastening and remove a spacer clip of a cover of the bottom, and also facing of a longitudinal beam in area of ​​a wing.

5. Disconnect the door entry plate from the clamp holder using a plastic wedge and remove.

6. Insert a plastic wedge into the gap between the wing and the lining of the longitudinal beam and remove the lining from the two clip holders (arrow in the illustration).

Removing the door entry plate from the clamp holder Mercedes-Benz W203

1 - wing;

2 - lining of the longitudinal beam;

3 - wing nuts.

7. Turn away 2 nuts of fastening of a wing. 

8. Open the hood and set it upright.

9. Turn out bolts and remove a wing.

Removing the fender Mercedes-Benz W203

1 - bolts;

2 - wing;

3 - cover;

4 - sealing tape.

10. Detach the cover and sealing tape.

Installation 

1. Installation is carried out in the reverse order of removal.

At the same time, make sure that the hood closes correctly, as well as the clearance in relation to the front door and the hood. The gap value is given in the Specifications.

2. Reinstall the front wheel so that the marks made during removal match. Pre-lubricate with a thin layer of bearing grease the centering belt of the wheel disk on the hub. Do not grease wheel bolts. Replace rusty bolts. Wrap bolts. Lower the car onto the wheels and tighten the bolts crosswise to 110Nm.

The article is missing:

  • Tool photo
  • Photo of parts and consumables
  • High-quality repair photos
  • Repair Descriptions

Source:  http://www.auto-knigi.com/model/mb_c/13_1_20/

favorite 0
print
share
bookmark_border
None