Removing and installing the driver's airbag Nissan Qashqai 2007 - 2013

Tools:

• Screwdriver flat medium
• Open-end wrench 10 mm

Note:

The driver's airbag must be removed when repairing the vehicle's steering and electrical components, so the process of removing and installing it is described in this manual. However, to avoid injury, strictly observe the following safety rules:

• Before removing the airbag, be sure to disconnect the wires from the negative terminal of the battery to avoid accidental deployment of the airbag.
• After disconnecting the wire from the "minus" terminal of the battery, you must wait at least 60 seconds, and only after that you can proceed to remove the airbag.
• Do not disassemble the airbag module.
• Do not drop the airbag module or allow water, grease or oil to come into contact with it.
• The airbag module must not be exposed to temperatures above 93°C.

Removing and installing an airbag on a Nissan Qashqai

1. Disconnect a wire from the minus plug of the storage battery.

2.  On the reverse side of the steering wheel, through the holes, wring out the latches (one on each side) of the airbag module.

3. Gently lift the module and move it away from the steering wheel hub.

4. Disconnect a conclusion "minus" of a sound signal.

5. Press the latch of the wiring harness of the audio system and on-board computer control module.

6. Disconnect the block from the connector.

7. Pry off the retainer of the Nissan Qashqai airbag module block with a screwdriver, lift it up.

8. Disconnect block from a pillow.

9. Similarly, disconnect the second connector from the airbag module.

10. Install the driver's airbag on the Nissan Qashqai in the reverse order of removal.

The article is missing:

• High-quality repair photos
• Tool photo

Source: http://nissan-qashqai.dv13.ru/sistemy-bezopasnosti/sistema-passivnoj-bezopasnosti-srs/snyatie-i-ustanovka-podushki-bezopasnosti-voditelya/