Removing and replacing the engine support bracket Audi A6 C6 2004 - 2011

Tool:

• Wheel chock (shoe)
• Ratchet wrench
• socket head 10 mm
• socket head 13 mm
• socket head 16 mm
• Box wrench curved 17 mm
• telescopic jack
• Bar 2 pcs. / telescopic jack 2 pcs.

Parts and consumables:

• Left engine bracket Audi A6 (if necessary) (4F0 199 351 H)

• Right engine bracket Audi A6 (if necessary) (4F0 199 352 E)

Notes:

1. Remove the engine crankcase protection as described in this article .

Engine protection Audi A6 C6.

2. Remove the anti-roll bar as described in this article .

3.  Engage I gear (translate the automatic transmission selector to the “P” position) and install the chocks “boots” under the rear wheels.

Note:

If you need to remove two brackets, then you need to loosen the fasteners on two brackets.

4.  Loosen (tear off) the engine mount bracket to the beam.

5. Loosen (tear off) the attachments to the side member in the same way.

6. Completely unscrew the nuts to which the Audi A6 engine mount is attached.

7.  Jack up the front of the car.

Note:

We use a pneumatic jack, but you can use any other.

Pneumatic jack.

8. Place a block (or jack) under the car (the place is indicated by an arrow).

9. Lower and remove the jack.

10. Similarly, substitute the second support under the other side.

11. Finally unscrew all engine bracket fasteners.

12. Remove the engine bracket.

Bracket seat.

Audi A6 engine mount bracket.

13. Install all removed parts in the reverse order of removal.

The article is missing:

• Tool photo

Source: carpedia.club

The article is missing:

• Tool photo

The article lacks:

• Фото инструмента