Removing the rear door trim Hyundai Creta

Note:

The casing is removed to replace the elements of the door: power window, lock, glass, speaker or door opening limiter, as well as to repair the door itself.

The trim on the right and left rear doors of the Hyundai is removed in the same way.

Helpful advice:

Before starting work, get a few spare fasteners for fastening the skin, as they often break during the removal process.

Removing the rear door trim Hyundai Creta

1.  Place the vehicle on a level surface and turn off the ignition.

2.  Open the back door.

3. In the niche of the Hyundai Creta door, pry with a flat screwdriver and lift the plug.

4. Use a Phillips screwdriver to remove the screw.

5. Starting from the bottom, slowly pull towards you and pull the trim holders out of the door panel.

6. Move the trim aside.

7. Press a clamp and disconnect drafts of a drive of the lock from the handle of a door.

8. Wring out and disconnect the block of wires from the power window button.

9. Remove the Hyundai Creta tailgate trim. 

10. If necessary, replace with a new one.

11. If it is necessary to remove the protective film, unscrew the 2 fastening screws and remove the bracket. Then remove the film.

12.  Check up a condition of holders of a covering of a door.

13. Replace damaged holders with new ones.  

14. Establish a covering of a back door of Hyundai Crete in an order, the return to removal.

15. Press it firmly against the door panel so that the latches are firmly fixed in the holes.

Similar articles:

Removing the front door trim Hyundai Creta

Removing the tailgate trim Hyundai Creta

Source:  carpedia.club