Installing the valve block of an automatic transmission Toyota Camry 2001 - 2006

Tools:

• Nozzle on the collar
• torque wrench

Parts and consumables:

• Automatic transmission fluid
• Oil pan gasket
• Oil filter
• Oil filter sealing ring
• Transmission fluid temperature sensor O-ring
• THREE BOND 2430 Sealant or equivalent
• Funnel
• 2 magnets

1. Install 5 shift solenoid valves and secure with 5 bolts.

Torque:

• bolt A: 6.6 Nm;
• bolt B: 10.8 Nm.

Bolt length:

• bolt A: 12 mm;
• bolt B: 45 mm.

Installing the shift solenoid valves

2. Install the spring and check valve body. Align the groove of the manual valve with the pin on the lever.

3. Install 17 mounting bolts. Tightening torque: 10.8 Nm.

Bolt length:

• bolt A: 25 mm;
• bolt B: 41 mm;
• bolt C: 45 mm.

The order of tightening the bolts of the valve block

Note:

To install the valve, sink the valve block, overcoming the action of the accumulator piston spring and the check valve body. First, temporarily tighten the bolts marked with an asterisk in the figure, as they are installation bolts.

4. Lubricate the new oil filter O-ring with automatic transmission fluid.

5. Install the oil filter O-ring.

6. Install the oil filter and secure it with 3 bolts. Tightening torque: 10.8 Nm.

7. Lubricate the new transmission fluid temperature sensor O-ring with automatic transmission fluid.

8. Install the transducer, bolt and retainer plate. Tightening torque: 6.6 Nm.

9. Connect the 5 shift solenoid valve connectors.

10. Install 2 magnets in the oil pan.

11. Lubricate the pan mounting bolts with sealant.

Note:

THREE BOND 2430 sealant or equivalent.

12. Install the oil pan , gasket and tighten the 18 bolts. Tightening torque: 7.8 Nm.

Note:

Since the bolts must be tight, apply sealant to them and tighten 15 minutes after applying the sealant.

13. Fill in and check up a working liquid of an automatic transmission.

Source: http://carmanz.com/toyota/camry-2001-2006/232692-tc2001605.html