Citroen
Berlingo
2 generation [restyling] [2012 - 2015]
Petrol
2 generation [restyling] [2012 - 2015]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Add to garage Filter

Replacing headlight bulbs Citroen Berlingo II 2012

print share bookmark_border
0 Views
0.0 Rating
No tool
Not indicated
Car services nearby

Parts and consumables:

  • Cloth gloves
  • rags
  • Headlight lamp (low and high) - H4 - 55W - 6216.30

Headlight bulb H4 55W 6216 30 Citroen Berlingo II

  • Turn signal lamp - PY21W - 21W (yellow) - 6216.31

Turn signal lamp PY21W 6216 31 Citroen Berlingo II

  • Position lamp - 12V - W5W - 6216.32/6216.A1

Notes:

This manual also applies to Peugeot Partner vehicles.

On the Citroen Berlingo, lamp replacement is carried out only with the ignition off or with the battery disconnected .

Wait about three minutes after changing the bulb before connecting the on-board power supply to the battery. After installing a new lamp, check its operation.

For the left and right headlights of the Citroen Berlingo 2, the lamps are replaced in the same way.

The structure of the front headlight of the car Citroen Berlingo II

Headlight Citroen Berlingo 2:

1 - Headlight low / high beam;

2 - Turn indicator.

3 - Marker lights. 

1.  Raise the hood. To reach the lamps, you need to stick your hand from the back of the optical unit.

Access point to the rear side of the Citroen Berlingo II headlight optical unit

2. To replace the low beam / high beam lamp  (1), remove the central protective casing by pulling the rubber tab that closes the headlamp from moisture penetration. 

Removing the central protective cover of the Citroen Berlingo II headlight bulb

3. Disconnect the electrical connector block.

Disconnecting the electrical connector for the Citroen Berlingo II headlight bulb

4. Remove the latch tab.

Removing the Citroen Berlingo II headlight retainer tab

5. Remove the bulb. 

Removed Citroen Berlingo II headlight bulb

Warning:

Do not touch the lamp bulb with your fingers, as the halogen lamp gets very hot and grease stains will cause the bulb to darken. Handle the bulb by the bulb only with clean gloves or a clean cloth.

6. Replace the lamp by carefully aligning its base with the guide slots on the block.

Replacing and installing headlight bulb headlights Citroen Berlingo II

7. Replace the latch tab and connect the electrical connector block. Be sure to fit the casing tightly around the perimeter to ensure a tight seal.

Citroen Berlingo II Headlight Retainer Tab and Headlight Plug Reinstalled

8. To replace the turn signal bulb  (2), remove the protective cover by pulling on the rubber tab.

Removing the protective casing of the Citroen Berlingo II direction indicator lamp

9. Remove the lamp holder by pulling on the connector block.

Removing the headlight bulb holder Citroen Berlingo II

10. Press lightly on it and turn counterclockwise. Replace lamp. Install the new bulb in the reverse order of removing it. 

Unscrewing the headlight turn signal lamp Citroen Berlingo II

11. Make sure the casing is tight around the perimeter to ensure a tight seal.

12. The size illumination lamp is replaced in a similar way.

Headlight bulb 12V W5W, 6216.32/6216.A1 Citroen Berlingo II

Clearance lamp

The article is missing:

  • Photo of parts and consumables

Source: carpedia.club

favorite 0
print
share
bookmark_border
None