Oil change in automatic transmission Hyunday Santa Fe CM 2006-2012

Tools:

• Ratchet wrench
• Head 10 mm
• Head 13 mm
• Head 24 mm

Parts and consumables:

• Technical capacity
• rags
• Oil funnel

• Oil for automatic transmission (04500-00400 - capacity 4 l; 04500-00100 - capacity 1 l)

• Drain Plug Crimp Washer (21513-11000)

• Automatic transmission drain plug (if necessary) (45324-39000)

Note:

This article shows an oil change in a Santa Fe automatic transmission.

The manufacturer does not provide for the replacement of the working fluid in an automatic transmission (automatic transmission) during the entire service life. However, sometimes the need to replace the working fluid may arise, for example, when repairing a gearbox. It is recommended to replace it without fail even if the automatic transmission has been immersed in water while driving off-road.

A complete replacement of the working fluid can only be carried out using a special installation, therefore, for a complete replacement of the working fluid, contact a specialized service center. In garage conditions, in the absence of a special installation, only a partial replacement of the fluid can be carried out, this process is described below.

Fill the automatic transmission with HYUNDAI GENUINE ATF SP-III, DIAMOND ATF SP-III, SK ATF SP-III or other brands approved by Hyundai Motors.

1. Warm up the oil to an operating temperature of 70-80 °C (make a short trip in the city cycle).

2. Remove the engine crankcase protection as described in this article .

3. Loosen the oil drain plug.

4. Place a container under the drain hole and unscrew the plug by hand.

Note:

Inspect the plug, the plug is equipped with a magnetic insert to trap and hold lapping products and natural wear of the steel elements of the gearbox. The plug is sealed with a crimp washer. If the washer is severely deformed, be sure to replace it.

Drain plug.

Useful advice:

If a lot of chips are stuck on the insert, contact a specialized technical center for advice.

5. Clean the plug and replace the compression washer if necessary.

6. Screw the drain plug into the gearbox oil pan.

7. Remove the automatic transmission oil dipstick.

8. Insert a funnel into the dipstick guide and fill the Hyundai Santa Fe automatic transmission with oil (fill in as much fluid as was drained).

Note:

On engines 2.4 and 2.7 liters. the volume of oil in the box is 8.5 liters.
On engines 2.2 liters. the volume of oil in the box is 10.9 liters.

Warning:

The ingress of even a small amount of mechanical impurities into the working fluid of the box is unacceptable. Therefore, before removing the oil level indicator (dipstick), carefully wipe the surface around it from dirt.

9. Replace the dipstick and start the engine, let it idle for about 5 minutes.

10. Check the Santa Fe oil level in the box as described in this article . Add oil to the Santa Fe box if necessary.

Warning:

Do not exceed the maximum permissible level of the working fluid, as this can lead to transmission failure.

11. Install all removed parts in the reverse order of removal.

The article is missing:

• Tool photo
• Photo of parts and consumables

Source:  http://carpedia.club/