Tool:
- Battery charger
Parts and consumables:
- Electrolyte density 1.4
- Distilled water
- Concentrate
1. Remove the battery.
2. Peel off the sticker that hides the plugs.
3. Check the level in the banks.
4. We put the battery on the charger for a full cycle, 10-12 hours.
5. After charging, check the density.
6. If the density is 1.16 (or any low density), then you need to raise it.
7. We take an electrolyte of density 1.4, distilled water and begin to raise the density to 1.27.
8. Dilute with concentrate and put it on charge again. And so on until we equalize the density in all banks to 1.27.
The article is missing :
-
High-quality repair photos
Source: https://drive2.ru/l/5602217/

Replacement of pipelines of a brake drive from the main brake cylinder to the hydraulic control device.
[[ article.getBookmarkIcon() ]]
lift

Removal and installation of the ceiling, soundproofing.
1 to 3 hours
[[ article.getBookmarkIcon() ]]
Instrument


Checking the technical condition of the Skoda Rapid rear suspension parts.
[[ article.getBookmarkIcon() ]]
lift

Removal of ceiling handles and installation of microlifts.
30 minutes - 1 hour
[[ article.getBookmarkIcon() ]]
Instrument

Checking and adjusting the tension of the alternator drive belts, air conditioning compressor, water pump and power steering pump.
30 minutes - 1 hour
[[ article.getBookmarkIcon() ]]
lift



Replacing the cabin filter of the Skoda Rapid heating and air conditioning system
5 - 30 minutes
[[ article.getBookmarkIcon() ]]
No tools