Removal and installation of facing of a door of a back Nissan Qashqai

You will need: Flat and Phillips screwdrivers.
Facing of a tailgate consists of two parts: top and bottom.
The upper part of the cladding can be removed without the use of tools. You will need a Phillips screwdriver to remove the bottom trim.

1. Open the tailgate.

2. Pull the tailgate cable end...

3. ... and, overcoming the resistance of the latch, remove the tip from the holder on the tailgate.

4. Turn out the screw of fastening of the bottom part of facing of a door of a back located in recess of the handle.

5. Gently prying off the edge of the lower part of the tailgate lining ...

6. ... disconnect the lining, overcoming the resistance of the plastic caps, and remove it.

NOTE.

Facing (view from the back) is attached to the door panel with thirteen plastic caps.

Replace damaged caps with new ones by removing them from the cladding brackets.

7. Pull the upper central part of the rear door lining towards you and disconnect it, overcoming the resistance of the plastic caps.

8. Disconnect facing of a door of a back on the right …

9. ... and on the left and remove the lining.
10. Establish facings of a door of a luggage carrier in an order, the return to removal.

Source: http://nissan-qashqai.dv13.ru/kuzov/snyatie-i-ustanovka-oblicovki-dveri-zadka/