Removal and installation of the anti-roll bar Skoda Fabia

Tools:

• torque wrench
• Open-end wrench 17 mm
• T-shaped socket wrench 13 mm
• T-shaped socket wrench 17 mm

Parts and consumables:

• Anti-roll bar (if necessary, replace)
• Stabilizer bar pads (replace if necessary)

1.  Remove the engine crankcase mudguard. The type of mudguard (engine crankcase protection) may be slightly different.

2.  Turn away two bolts 3 fastenings of a back support 2 of the power unit to a transmission.

3.  Turn away on both parties of a suspension bracket on two bolts 2 fastenings of clips of pillows of a bar of the stabilizer. The lower bolt on the right side can only be removed after the front suspension beam has been lowered.

4.  Turn away from both parties of a suspension bracket on one nut 1 of fastening and disconnect racks 3 from a bar 2 of the stabilizer.

5.  Turn away bolts 1 of fastening of the steering mechanism to a beam 2 of a forward suspension bracket.

6.  Secure the steering gear with wire.

7.  Establish a reliable support under a beam of a forward suspension bracket.

8.  Turn away a bolt 4 from the left side of a beam. Screw centering pin 6 (T10096) instead and tighten to 20 Nm.

9. Turn away a bolt 4 on the right side of a beam. Screw centering pin 6 (T10096) instead and tighten to 20 Nm.

10.  Turn away bolts 1 from both parties (fig. in point 8 see).

11.  Unscrew bolt 2 (see figure in item 8) on the left side of the beam and remove bracket 5. Instead of bolt 2, screw in centering pin 6.

12.  Remove the support and lower the beam approximately 40 mm. At the same time, make sure that the power steering lines are not stretched.

13.  Remove both clips (fig. in point 3 see) pillows of a bar of the stabilizer.

14.  Having turned the bent ends of a bar (fig. in point 4 see) of the stabilizer upwards, remove a bar towards a back part of the car.

15.  Replace torn or loose stabilizer bar pads.

16.  Install the stabilizer bar in place. Carving connections of a suspension bracket finally tighten on the car standing on the earth.

The article is missing:

• Tool photo
• Photo of parts and consumables
• High-quality repair photos

Source:  http://www.autoprospect.ru