Removing and installing rear bumper Hyundai Accent MC

Tools:

• L-shaped socket wrench 10 mm
• Phillips screwdriver, medium
• Screwdriver flat medium
• Phillips screwdriver

Parts and consumables:

• Rear bumper (if required) (86611-1E000)

Note:

Step-by-step photo description of how to remove the rear bumper on a Hyundai Accent.

1. Open the trunk.

Note:

The lever for unlocking the trunk lid and the gas tank hatch is located on the left side at the bottom of the driver's seat.

2.  Turn out 3 clamps of a back facing of a luggage carrier.

3.  Remove the rear lining of the trunk from the four latches and remove it.

Latch for rear trunk lining

4. Remove the side clips of the trunk trim.

5. Turn off fastening of back lanterns (two nuts are not visible, they are shown by arrows).

6. Pull the headlight towards you and disconnect the 3 clips of the rear bumper.

7. Below, under the side trim of the trunk, unscrew the nut securing the Hyundai Accent rear bumper.

8.  Turn off self-tapping screws of fastening of a bumper to back wings.

9. Unscrew 2 screws securing the mudguard with a curved screwdriver (one self-tapping screw is not visible, its location is shown by an arrow).

10. Turn off the lower fastenings of a mudguard to a back bumper and remove a mudguard.

10.  Pull and overcoming the resistance of the plastic holder latches (shown in red circles), separate the left side of the bumper from the body.

11. Pull the bumper back until it is completely released from the clips.

12. Remove the three fastening clips from the bottom of the car and remove the rear bumper (for clarity, it is shown on the removed bumper).

Removed rear bumper Hyundai Accent

13.  Install the rear bumper on the Hyundai Accent in the reverse order of removal.

The article is missing:

• Tool photo
• Photo of parts and consumables

Source:  http://carpedia.club/