Removing the front bumper in a Ford Focus 2

Note:

We carry out work during the repair and replacement of the front bumper.
We perform work on a viewing ditch or overpass.

Removing the front bumper Ford Focus 2

On a car with a hatchback body, disconnect the wire blocks from the fog lights.
Remove the dirt shield from the engine compartment.

Remove the mudguard of the radiator of the cooling system.

Remove the radiator cover.

Using the Torx T-30 wrench, we unscrew the lower screw securing the right fender liner to the Ford Focus 2 bumper.

Loosen the top screw. 
Similarly, we turn off the screws securing the left fender liner to the bumper.

Using a Phillips screwdriver, unscrew the 2 screws of the upper bumper mount to the upper cross member of the engine compartment.

From the bottom of the car with a “10” head, we unscrew 2 self-tapping screws securing the Ford Focus 2 bumper to the right wing.
Similarly, we turn off the two bolts of the left bumper to the wing.

We take away the sidewalls of the bumper from the right and left wings, overcoming the resistance of the clamps.

The position of the latch on the right wing (for clarity, the headlight is removed)

Prying up the right holder of the upper cross member of the engine compartment, we remove the fixing tab of the bumper from it.
Similarly, we remove the left bumper lamp from the holder.

By pressing on the 3 bumper latches located in the center of the car, we remove them from the grooves of the upper cross member of the engine compartment.

Together with an assistant, remove the front bumper Ford Focus 2.
Install the front bumper in reverse order.

Source: http://wiki.zr.ru/233-1_%D0%A0%D0%B5%D0%BC%D0%BE%D0%BD%D1%82_Ford_Focus_II.