Removing the cigarette lighter in a Ford Focus 2

Let's say a piece of paper is a torpedo. Take out the cigarette lighter

So you pull out the cigarette lighter

You take a flashlight and look for green latches along the edges of the hole.

Here is one, you can see green plastic in the piece of iron.
Here is the second

We take a knife or a thin screwdriver and bend the metal away from the green plastic, that is, if you look at the cigarette lighter hole, you need to put the knife or screwdriver below the green plastic

The cloudy thing in the photo is a knife, you see where I inserted it, you see, now we bend the metal
The other side

Something like this, and bend the metal inward

When the metal is bent, insert your finger into the socket and pull it

Perhaps it will go tight, then you remove the plastic at the passenger's feet, there is one self-tapping screw, and behind the square pipe you will see the reverse side of the cigarette lighter

This one, you can try to squeeze it out from behind ...
As a result, it should turn out like this

That is, the green ring remains in the piece of paper (in this case, it is an imitation of the plastic of the torpedo) and the piece of iron is in the hands, the power chip will remain on it, remove it, but do not lose it, it will run into the hole - you will be tormented to get it later.
After that, we take out the plastic ring from the torpedo and remove the chip from the bulb holder

Then we align the bent metal, outside

One side

And the second

We assemble it like this: we put the connector on the contact of the backlight, here it is

We insert the ring, just insert it correctly, there is a notch on the ring and there is a place in the torpedo for this notch

Here she is
Inserted a new ring, or an old one with a new bulb

We thread the chip of the cigarette lighter itself with wires into the ring, connect it to the cigarette lighter and insert it
. Just do not press with all our might, first we center along the notches in the metal and on the ring

Here are 2 on one side and 1 on the other
. Also in the ring there are 2 bulges on one side and 1 on the other.

We insert, we center
And we sink to the end. That's it.

Source: https://www.drive2.ru/l/7306168/