Removing relays and fuses Renault Sandero

We carry out work when checking relays and fuses and replacing them. 

Warning : When removing relays and fuses, be sure to disconnect the wire terminal from the "negative" battery terminal.
To access the fuses and relays of the mounting block in the engine compartment, we move the lock of the block cover to the side ... 

... and, sliding the cover in the direction of the battery, remove it. 

A faulty fuse is determined by a blown jumper.
To remove the small fuse, use the tweezers-puller located in the cover of the mounting block in the cabin. 

Large fuses are removed by hand. In case of difficulty, gently pry it with the blade of a slotted screwdriver. 

Similarly, we remove the relay from the socket of the block.

Warning:  A new relay or fuse should only be installed in place of the failed one after the cause of the fault has been identified and corrected. It is allowed to use only standard fuses designed for a certain value of rated current (the value of the rated current of the fuse is indicated on its body). 
To access the fuse mounting block in the passenger compartment, pry the block cover from below with your finger and, overcoming the resistance of the latches, remove the cover. 

We take out the fuses from the block using tweezers-puller, as shown above.
Install new fuses and relays in reverse order. 

Source: http://wiki.zr.ru/241-2_%D0%A0%D0%B5%D0%BC%D0%BE%D0%BD%D1%82_Stepway