We are working on replacing the door glass.
Fully lower the glass.
Take off the door trim.
We pry off the front edge of the outer door glass seal and remove it from the outer door panel.
We pry off the rear edge of the inner door seal and remove it from the inner door panel.
Pull the sides of the glass seal out of the door.
We do not touch the upper part of the seal.
Having connected the wiring harness block to the power window switch, pry off the switch and raise the glass so that there is access to the self-tapping screws of the glass holders to the power window slider.
In this position, the self-tapping screws securing the glass holders to the power window slider will align with the holes in the inner door panel.
Using the Torx T-20 key, we unscrew the two screws securing the glass holders to the window regulator slider.
We take them out.
Turning the glass as shown in the photo.
We take it out of the door.
We remove the plastic holders of the rear window in the same way as the holders of the front glass.
Install rear door glass in reverse order.
Source: http://www.renault-duster.dv13.ru/kuzov/snyatie-stekla-zadnej-dveri/


