Removing the lock and outer handle of the front door Renault Logan 2004-2009 Gasoline

We carry out work when replacing the lock and the outer handle.
Operations are shown on the driver's door. The lock and handle of the right door are removed in the same way.
Take off the door trim. 

Using the Torx T-30 wrench, unscrew the screw securing the lower glass guide. 

We take out the glass seal from the guide. 

We bring the guide through the technological hole in the inner panel of the door ... 

... and remove the lower glass guide. 

By pressing the plastic latch of the rod 1 of the outer handle, turn it around the axis and disconnect the rod from the lock. 
In the same way, we disconnect the thrust of the 2nd cylinder mechanism of the lock.

We turn the rod of the lock lock button so that the protrusion on the rod falls into the slot of the latch ... 

... and remove the traction with the button. 

Using the Torx T-30 key, we unscrew the three screws securing the lock ... 

... and we remove the lock through the technological hole in the inner panel of the door.

Using a screwdriver, pry off the wire block retainer ... 

... and, having disconnected the block of wires, remove the lock assembly with the electric drive. 
If necessary, disconnect the rod of the inner handle for opening the door from the lock and remove the electric drive of the lock. These operations are the same as those shown on the tailgate lock.
Install the front door lock in reverse order.
To remove the outer handle of the front door, remove the lower glass guide and disconnect the outer door handle rod from the lock (see above).

With a “10” head, unscrew the two nuts securing the outer handle. 

We remove the outer door handle with the rod, overcoming the resistance of the two latches. 
Install the outer door handle in reverse order.
To remove the cylinder mechanism of the front door lock, remove the lower glass guide and disconnect the cylinder mechanism rod from the lock (see above).

Using a screwdriver, we move the bracket for fastening the cylinder mechanism of the lock ... 

... and remove the bracket. 

We take out the cylinder mechanism of the lock with the rod from the hole in the door. 
We install the cylinder mechanism of the lock with the rod in the reverse order, while the plastic lever 1 should be facing the rear of the door.

Front door lock with electric lock, external and internal handles 

Source: http://wiki.zr.ru/Kuzov_201_Remont_Logan_2005