Installing the clutch master cylinder Toyota Camry 2001 - 2006

Tools:

• Open-end wrench 10 mm.
• torque wrench

Parts and consumables:

• Grease
• Brake fluid Toyota Brake Fluid DOT3

Note:

Removing the Toyota Camry clutch master cylinder is described here .

1. Apply grease to the contact surfaces of the pin and bushing.

Grease application location on the contact surfaces of the pin and bushing

2. Connect the fork to the clutch pedal with the pin. Install the pin clamp.

Note:

Install the pin on the left side of the vehicle.

3. Connect the flexible hose and tighten the fastening nut. Tightening torque: 15.2 Nm.

4. Connect the clutch master cylinder reservoir tube with clamp to the clutch master cylinder.

Note:

Connect the clutch master cylinder reservoir tube so that it is not bent.

5. Install the brake booster.

6. Establish the main brake cylinder.

7. Remove air from the main cylinder.

8. Remove air from the brake system.

Removal of air from the brake system

9. After filling the master cylinder reservoir with clutch fluid, bleed the air from the clutch system .

10. Check and adjust the brake pedal height .

11 . Check and adjust the clutch pedal assembly .

12. Check for brake fluid leakage.

13. Check for clutch fluid leakage.

14. Check the fluid level in the clutch fluid reservoir.

The article is missing:

• High-quality repair photos
• Repair Descriptions

Source: http://automanualsrepair.ru/toyota/toyota83589.htm