Nissan X-Trail Front ABS Sensor Replacement

Nissan X-Trail Front ABS Sensor Replacement

1.  Park the vehicle on a level surface and turn off the ignition.

2.  Install wheel chocks on both sides under the rear wheels. 

3.  Loosen the wheel nuts about 1/2 turn using a 21mm Allen wrench or socket.

4.  Raise the front of the vehicle with a jack and place it on secure supports.

5.  Slowly lift the car up until the wheel is  2-3 cm  from the ground.

6.  Finally turn away nuts of fastening, and remove a wheel.

7.  Use a metal brush to clean the ABS sensor and the surface of the Nissan X-Trail steering knuckle from dirt.

8. Pry with a flathead screwdriver, pull out the latches and remove the 4 dust shield holders.

9. Fold it aside.

10. Use a flat screwdriver to squeeze out the latch and disconnect the block of wires from the front Nissan X-Trail ABS sensor.

11. Disengage the sensor harness from the holder on the mudguard.

12. Disengage the sensor harness from the 2 holders on the column.

13. Using a 10 mm wrench, remove the Nissan X-Trail front ABS sensor bolt.

14. Pry off the sensor with a flathead screwdriver.

15.  Remove from the steering knuckle and remove the sensor.

16. Replace Nissan X-Trail front ABS sensor with a working one.

17. Install the sensor in the reverse order of removal. Bolt of its fastening tighten the moment of 10 Н•м. Tighten the wheel nuts to  108 N•m.

Source:  carpedia.club