![1 generation [restyling] [2002 - 2012]](/uploads/Citroen_Berlingo_2002_-_2012_.jpg)
![2 generation [restyling] [2012 - 2015]](/uploads/Citroen_Berlingo_2012_-_2015_.jpg)
Parts and consumables:
- Engine oil
- Cloth gloves
- Rags/paper napkins
- Funnel
Notes:
In the period between scheduled oil changes, it is recommended to check its level every 5 thousand kilometers, and, if necessary, replenish it to normal.
If there is not enough oil in the engine, then it is subjected to severe overheating and, as a result, wear of parts and damage to the car.
There should be as much oil in the engine as indicated in the technical documentation for the car.
Checking the oil level should be carried out no earlier than 30 minutes after the engine has stopped.
1. Park the vehicle on a level surface and open the hood. The oil filler plug is located on the cylinder head cover. The oil level indicator (dipstick) with an orange plastic tip is located at the front of the cylinder block.
2. Before checking the oil level, remove the dipstick from the oil filler neck.
3. Rub the Citroen Berlingo 2 dipstick with a rag to make it dry.
4. Install the dipstick back into the neck until it stops, wait a few seconds until the oil leaves a mark on the control dipstick and remove it again.
5. Look at the oil level, which will be visible on the dipstick: it should be between the lower and upper risks, respectively. If the oil level is close to the bottom mark or even below it, add oil to the engine.
6. To add oil, turn the oil filler plug counterclockwise and remove it.
7. Fill Citroen Berlingo 2 engine oil into the engine, monitoring its level with a dipstick. Before removing the dipstick, wait 3 minutes for the oil to completely flow into the crankcase.
Note:
It is recommended to use a funnel to make it easier to pour oil into the engine, otherwise there is a risk of it spilling onto the engine block, which, when burned, will give an unpleasant odor and can lead to serious problems.
8. After topping up the oil, tighten the oil filler cap tightly.
Note:
To avoid engine damage or failure of the emission control system, do not use any engine oil additives. Top up with Citroen Berlingo 2 engine oil of the same brand, viscosity and type as the previously filled one.
The article is missing:
- Photo of parts and consumables
Source: carpedia.club
