Toyota Camry starter disassembly

Remove the starter housing assembly with the starter winding and armature from the traction relay housing.

Rice. 7.41 . Removing the wire terminal of the traction relay

Turn away a nut and disconnect the plug of a wire from an output of the traction relay ( fig. 7.41 ).

Rice. 7.42 . Bolts of fastening of a cover of a starter from outside a drive

Turn away two bolts of fastening of a cover of a starter ( fig. 7.42 ).

Remove the drive side starter cover.

Pull the starter housing complete with the stator winding and armature from the traction relay housing.

Rice. 7.43 . Removing the spring ring

Using thin-nosed pliers, remove the spring ring ( Fig. 7.43 ).

Rice. 7.44 . Bolts of fastening of a cover of a starter from the switchboard

Turn away two coupling bolts of fastening of a cover of a starter from the switchboard ( fig. 7.44 ).

Remove the cover from the side of the switch.

Rice. 7.45 . Removing the steel ball from the hole in the freewheel shaft

Using a magnetic rod, remove the steel ball from the hole in the overrunning clutch shaft ( Fig. 7.45 ).

Rice. 7.46 . Removing the brush holder

Using a screwdriver, depress the brush spring and disconnect the brush from the brush holder. Disconnect the four brushes and remove the brush holder ( Fig. 7.46 ).

Make sure the positive (+) wire is not shorted to ground.

Remove the anchor from the starter housing.

Retrieved from http://carmanz.info/toyota/camry-2001-2006/234782-tc2001814.html#ixzz3gbheDRD1