Contents
Nissan
Note
E11 [2004 - 2012]
Petrol
E11 [2004 - 2012]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Add to garage Filter

Removing and installing the front seat Nissan Note 2004 - 2012

print share bookmark_border
0 Views
0.0 Rating
Tool
30 minutes. - 1 hour
Car services nearby
Tools:
Screwdriver flat medium 1 pieces
Socket head 16 mm 1 pieces
Parts and consumables:
Anaerobic threadlocker 1 pieces

Note:

The principle of removing the front seat on the Nissan Note is the same on both sides.

Removing the front seat Nissan Note

Removing and installing the front seat Nissan Note 2004 - 2012

1. Disconnect the negative terminal wire from the battery.

Removing and installing the front seat Nissan Note 2004 - 2012

2. Move the front seat all the way back.

3. Remove the two front decorative overlays of the seat guide sled.

Removing and installing the front seat Nissan Note 2004 - 2012

4. Turn out 2 forward bolts of fastening of a slide of a seat to the basis of a body.

Removing and installing the front seat Nissan Note 2004 - 2012

5. Then move the seat all the way forward.

Removing and installing the front seat Nissan Note 2004 - 2012

6. Remove the two rear trims for the seat rails.

Removing and installing the front seat Nissan Note 2004 - 2012

7. Turn out 2 back bolts of fastening of a slide of a seat to the basis of a body.

Removing and installing the front seat Nissan Note 2004 - 2012

8. Tilt the front seat of the Nissan Note back. This will open access to the wiring harness pads.

Removing and installing the front seat Nissan Note 2004 - 2012

9. Squeeze the latch and disconnect the wiring harness block from the seat heating block.

10. Squeeze the latch and disconnect the harness block from the seat belt signal lamp block.

11. Remove the Nissan Note seat and pull it out of the car. 

Removing and installing the front seat Nissan Note 2004 - 2012

12.  Apply an anaerobic threadlocker to the seat bolts before installation. Install the seat in the reverse order of removal.

Source: carpedia.club

favorite 0
print
share
bookmark_border
alino4karivne