Removing and installing the driver's airbag Nissan Note 2004 - 2012

How to remove the driver's airbag on a Nissan Note

1. Raise the hood and secure it with the stop.

2. Disconnect the wire from the "negative" terminal of the battery and wait about 15 minutes (for the activator capacitor to completely discharge).

Warning:

Attempting to remove the airbag module on a Nissan Note without powering it off may cause the airbag to deploy unexpectedly.

3. Pry with a screwdriver and remove the plugs of the spring clips of the airbag module on both sides of the steering wheel. 

4. Through the open holes in the steering wheel cover, press the spring clips of the Nissan Note airbag.

5. Disconnect the module from the steering wheel.

6. Disconnect a wire of a sound signal from a socket on a pillow of safety.

7. Use a screwdriver to pry the wiring harness block retainer, lift it up, and disconnect the block from the driver's airbag module terminals.

8. Remove the Nissan Note airbag from the steering wheel.

9. Install the airbag on the Nissan Note in the reverse order of removal.

Note:

• Self-disassembly of the Nissan Note airbag module  is prohibited .
• Do not drop the airbag module or allow water, grease or oil to come into contact with it.
• The airbag module must not be exposed to temperatures above 95°C.

Source: carpedia.club