![XV30 [2001 - 2004]](/uploads/Toyota_Camry_XV30_2001_-_2004_.jpg)
Disconnect the terminals from the battery.
Set the steering wheel straight.
Using a socket wrench (Torx), unscrew the 2 bolts securing the side plugs with an Allen socket.
Remove the plugs.
|
|
|
Rice. 5.17 . Loosening the steering wheel pad mounting bolts
Loosen the steering wheel pad mounting bolts. Loosen the bolts until they lock as shown in Figure 5.17 .
Take out an overlay of a steering wheel.
|
ATTENTION Do not pull the pad sharply. Be careful not to break the steering airbag wire connectors. |
|
|
|
Rice. 5.18 . Airbag wire connectors
Using a screwdriver, disconnect the 2 steering airbag wire connectors as shown in Figure 5.18 .
Remove the steering wheel cover.
|
|
Rice. 5.19 . Steering wheel pad content rule
|
ATTENTION For the entire time of work, in order to avoid damage, keep the overlay face up ( Fig. 5.19 ). Do not attempt to remove the steering airbag capsule. |
|
|
|
Rice. 5.20 . Removing the steering wheel
Mark the steering wheel and main shaft. Using a special tool, unscrew the steering wheel nut and remove the steering wheel ( Fig. 5.20 ).
|
|
|
Rice. 5.21 . Bolts of fastening of the top casing of a steering column
Screwdriver, unscrew the 2 screws securing the upper casing of the steering column ( Fig. 5.21 ).
After unscrewing the three bolts, remove the cover of the lower casing No. 2.
With the connector disconnected, remove the headlight dimmer assembly.
Remove the coiled wire combination switch.
With the connector disconnected, remove the wiper switch assembly.
|
NOTE Do not disassemble the coiled wire and avoid getting oil on it. |
|
|
Rice. 5.22 . Fastening of finishing of a threshold of a forward door
Remove the front door sill trim by disconnecting 7 retainers and 4 fastening clips ( Fig. 5.22 ).
|
|
|
Rice. 5.23 . Fastening of a lateral decorative slip of salon
Disconnect the 2 clips and remove the side trim trim salon ( Fig. 5.23 ).
|
|
|
Rice. 5.24 . Fastening the lower trim panel on the driver's side
Turn away two bolts, disconnect a cable of the lock of a cowl. Disconnect the three fastening clips and remove the lower trim panel from the driver's side ( Fig. 5.24 ).
Loosen the four screws and remove the bottom trim panel insert.
|
|
|
Rice. 5.25 . Instrument cluster trim fixture
Unscrew the two screws, disconnect the 2 mounting clips and remove the instrument cluster trim ( Fig. 5.25 )
Remove the ignition lock trim.
Source http://carmanz.info/toyota/camry-2001-2006/233552-tc2001691.html#ixzz3gGbu7Nvq
