Installing the intake camshaft of the rear head of the engine block model 1MZ-FE Toyota Camry 2001 - 2006

Tools:

• Nozzle on the crank 10 mm
• torque wrench

Parts and consumables:

• Motor oil

Note:

Installation of the camshaft of the exhaust valves of the rear head of the engine block of the 1MZ-FE Toyota Camry model is described here .

1. Apply a layer of engine oil to the end thrust surfaces of the camshaft.

2. Engage the exhaust and intake camshaft drive gears by aligning the alignment marks (two points) on the gears with each other.

Combination of labels of gear wheels of a drive of a camshaft

3. Install the intake camshaft to the cylinder head.

4. Install the bearing caps according to the markings on their housings.

Bearing cap markings

5. Apply a light coat of engine oil to the threads and under the heads of the bearing cap bolts.

6. Install and evenly tighten the ten bearing cap bolts in several passes to 16 Nm in the sequence shown in the figure.

Tightening procedure for bearing cap bolts

7. Turn away a technological bolt.

The article is missing:

• High-quality repair photos

Source: http://carmanz.com/toyota/camry-2001-2006/231322-tc2001468.html