I used masking tape. Really works. No need to buy madeleine. I just glued the inserts themselves. Time spent 10-15 min.
We hook it from below and snap off the lining.
We glue along the entire contour.
Well, that's enough, then we snap it in and with strong compression with our fingers, we understand the plastics are one, like a monolith.
But tearing off the tape, so that it would not be visible is difficult.
Source: https://www.drive2.ru/l/1673469/
Removing the additional electric heater of the Renault Duster interior
[[ article.getBookmarkIcon() ]]
Instrument

Removing the absolute air pressure sensor Renault Duster
5 - 30 minutes
[[ article.getBookmarkIcon() ]]
Instrument
Checking and replacing the brushes of the Renault Duster generator
[[ article.getBookmarkIcon() ]]
Instrument
Removing the camshafts and replacing the hydraulic bearings of the Renault Duster valve levers
[[ article.getBookmarkIcon() ]]
lift
Replacing the right engine mount Renault Duster
30 minutes - 1 hour
[[ article.getBookmarkIcon() ]]
lift