Replacing the hazard warning switch button and seat belt signaling unit Nissan Qashqai 2007 - 2013

Tools:

• Phillips screwdriver, medium
• Small flat screwdriver
• Open-end wrench 10 mm

Parts and consumables:

• Hazard switch button
• The block of signaling devices of not fastened seat belts

1. Disconnect a wire from the minus plug of the storage battery.

2. Gently wring out a screw-driver spring clamps on the right side of the central overlay of the instrument panel in its middle part.

3. Overcoming the elastic resistance of the latches, lift the trim from the instrument panel and disconnect the wiring harness pads from the alarm switch button and from the seat belt signaling unit. Remove the central overlay of the panel of devices.

4. Wring out clamps of a key of the switch of the alarm system.

5. Take a key from an aperture of the central overlay of the panel of devices.

6. Turn out two screws of fastening of the block of signaling devices of not fastened seat belts to the central overlay of the panel of devices.

7. Remove the block of a signaling device of not fastened seat belts.

8. Install the hazard switch button and the new seat belt warning unit in the reverse order of removal.

The article is missing:

• High-quality repair photos
• Tool photo

Source:  http://nissan-qashqai.dv13.ru/elektrooborudovanie/zamena-klavishi-vyklyuchatelya-avarijnoj-signalizacii-i-bloka-signalizatorov-nepristegnutyx-remnej-bezopasnosti/