Hyundai Creta high and low beam bulb replacement

Note:

Before replacing the lamp with a Hyundai, it is advisable to disconnect the wire from the “negative” battery terminal with a 10 mm wrench.

For good and uniform illumination of the road, it is recommended to replace the bulbs in pairs.

Replacing the dipped and high beam bulb Hyundai Creta

1.  Place the car on a level surface, and turn off the ignition.

2.  Raise the hood cover and fix it with an emphasis.

3.  Turn counterclockwise and unscrew the headlight cover.

4.  Remove it from the headlight housing.

5. Disconnect from a bulb of a passing/high beam Hyundai a block of wires.

6. Disengage the spring clip.

7. Remove the burnt out bulb from the headlamp socket.

8. Replace Hyundai Creta low/high beam bulb with a working one. Lamp type - H4 / 60 / 55 W.

Note:

Do not install a light bulb with dimensions of greater power than indicated in the instructions.

Depending on the equipment, a halogen lamp with a 9005  HB3/60 W connector can be installed in the vehicle.

9. Install the new bulb back into the headlight housing.

10. Secure with a spring clip and connect the wire block.

11. If necessary, in the same way, replace the second high and low beam lamp with the Hyundai Creta.

12. Check and adjust the headlights. 

Source:  carpedia.club