Replacing the rear door handle in a Mitsubishi Lancer 9 car

Hello everyone, today I will talk about another problem.
Once a child with a psycho pulled the rear handle of the left door and ... it escaped like this:

It was unpleasant, but he did not scold the child, but scolding him a little, for decency, he suspected something was wrong with the pen. And right!
The handle should have two bolt fasteners and a latch so that it does not move away from the door at moments of load:

1 and 2 - soldered nuts for bolting, 3 - retainer. Photo from the Internet from the front doors, but the meaning is the same ...

The analysis showed that I did not have nut number 2 (hello to the previous owner again) and the handle was held on bolt fastening number 1 and on a plastic retainer 3, which is not designed for loads, but simply held the handle tighter to the body.

After thinking, I decided to restore the handle, but put a bolt on the poxypol into the socket for the nut, and fasten it with a nut on the other side. Having degreased the surface, poxypol was poured into the hole for the nut and a bolt was planted, then everything was carefully smeared on top and sent for drying. After drying, the door was assembled and everything worked, cheers!

Yesterday, a week later, after the rains, there was a sharp heat and damp closeness. And as a result, the bolt vomited.

Today, a handle was purchased at a disassembly and replaced.

Good luck to all!

Source: http://www.drive2.ru/l/6982664/