Removing and replacing the starter Mitsubishi Outlander 2003 - 2008

Tools:

• Straight box wrench 10 mm
• Collar for end cap 3/4"
• Nozzle on the crank 10 mm
• Nozzle on the crank 6 mm

Parts and consumables:

• Starter (Mitsubishi 1810A001) (if replacement is necessary)

Starter layout

1 - sterter cover;

2 - connector and current wire of the starter;

3  - bolts for fastening the clutch slave cylinder;

4 - bracket for fastening the flexible hose of the clutch drive;

5 - starter;

6 - starter cover bracket.

Order of execution

1. Disconnect the "minus" terminal from the battery contacts.

2.  To facilitate access to the starter, it is recommended to dismantle the housing and air filter pipe.

3. Remove the cover (protection) of the starter, which is screwed to the starter with two bolts on the left side.

4. Disconnect the terminal and current wire from the starter.

5.  Remove the mounting bolts and remove the starter ( 5 ).

Starter

6.  Clean and check the starter. If necessary, disassemble and repair the starter or replace with a new one.

7.  Assemble all parts in reverse order.

The article is missing:

• Photo of tools
• High-quality repair photos

Source:  http://carpedia.club