Engine starting

Combined ignition switch

1. If the vehicle is equipped with a manual transmission, move the gearshift lever to neutral and fully depress the clutch pedal.

2. If the car is equipped with an automatic transmission, move the selector to position "P" ("Parking").

3. To start the engine, insert the key into the ignition switch and turn it to the "START" position. Release the ignition key immediately after starting the engine. Do not hold the ignition key in the "START" position for more than 15 seconds.

Note:

For safety reasons, the vehicle cannot be started unless the automatic transmission selector is in P (Park) or N (Neutral) (automatic transmission vehicles only).

Ignition switch positions

"LOCK": "Lock".

"ACC": "Optional equipment".

"ON": "Enabled".

"START": "Starter".

Ignition switch positions

START.

In this position, the starter operates. It turns the engine crankshaft until the ignition is turned off.

ON.

In this position, the engine is running and all electrical systems can be switched on. Do not leave the ignition key in the "ON" position when the engine is not running. This will lead to the discharge of the battery and the failure of the ignition system.

"ASS".

When the ignition key is in this position, you can turn on some electrical systems (radio, cigarette lighter, etc.).

"LOCK".

The ignition key can only be inserted or removed in this position.

Note:

To unlock the steering wheel, insert the key into the ignition switch and turn the steering wheel slightly while turning the ignition key.

– turn the ignition key to the “ACC” position. To remove the key from the ignition switch:

– Simultaneously press and turn the ignition key counterclockwise from the “ACC” position to the “LOCK” position.

Removing the key from the ignition

Starting the engine (for vehicles with a multiport fuel injection system)

Engine starting

1. The driver and all passengers in the car must fasten the appropriate seat belts.

2. Check that the parking brake is on.

3. Press the brake pedal.

Vehicles with manual transmission

4a.  Fully depress the clutch pedal and move the shift lever to neutral. Hold the clutch pedal fully depressed while the starter is operating.

Vehicles with automatic transmission

4b. Move the range selector lever to the P (Park) position. If it is necessary to start the engine while the vehicle is moving, move the range selector lever to the "N" (Neutral) position.

Note:

Cars with automatic transmission.

Starter engagement is disabled unless the range selector lever is in the P (Park) or N (Neutral) position.

5. Turn the ignition switch to the "START" position and hold the handle in this position until the engine starts (but no longer than 10 seconds).

6. After starting, let the engine idle for approximately 10 seconds.

Note:

If the key is difficult to turn in the ignition lock, move the steering wheel from side to side to relieve the load on the locking element.

The article is missing:

• High-quality repair photos

Source:  http://automn.ru/hyundai-matrix/hyundai-37124-10.m_id-4925.m_id2-4932.html