Skoda
Octavia
1 generation [restyling] [2000 - 2010]
Petrol
1 generation [restyling] [2000 - 2010]
Maintenance
Body and Interior
Undercarriage
Transmission
Steering
Brake system
Engine
Electrical equipment
Ventilation and air conditioning system
Security system
Spare parts and consumables
Daily maintenance
Regular maintenance
Other articles…
Add to garage Filter

Checking the level and topping up the fluid in the power steering reservoir Skoda Octavia I Tour 1996 — 2010

print share bookmark_border
0 Views
0.0 Rating
Tool
Not indicated
Car services nearby

Tools:

  • Screwdriver flat medium 

Parts and consumables:

  • rags
  • Funnel (optional)
  • Power steering fluid VAG Power Steering Fluid G004 (G004000M2)

Power steering fluid VAG Power Steering Fluid G004 (G004000M2)

Notes:

The hydraulic booster ​Skoda Octavia Tour is part of the steering mechanism to make it easier to turn the steering wheel and set the trajectory.

The power steering fluid level should be checked at every maintenance, as well as when a fluid leak is detected from the hydraulic drive of the booster, when steering efficiency is reduced or extraneous noise (howl) occurs when the steering wheel is turned. 
It is important to locate the leak as accurately as possible, as it is likely that a worn or damaged part will need to be replaced.

If you often top up the power steering fluid, then there are leaks somewhere, which should be repaired immediately after detection.

Top up the special fluid of the G002 (G004) standard recommended by the manufacturer into the hydraulic booster reservoir.

Check the power steering fluid level with the engine off. 

1.  Park the vehicle on level ground, allow the engine to cool, and  open the hood.  The power steering reservoir is located on the right side of the engine compartment (next to the coolant reservoir) in the direction of vehicle travel. 

Location of the power steering reservoir in the engine compartment of the Skoda Octavia I Tour

2.  To check the fluid level, first turn the power steering reservoir cap counterclockwise. 

The direction of rotation of the cover to open the power steering reservoir Skoda Octavia I Tour 

3. Get a cover together with the index (probe) of level of working liquid.

Removing the cap along with the dipstick from the power steering reservoir Skoda Octavia I Tour

4. Wipe the pointer (probe) with a clean cloth and screw the cap back on.

Power steering fluid level gauge Skoda Octavia I Tour

5. Unscrew the cover with the pointer (probe) again. The pointer (probe) is marked MAX (maximum) and MIN (minimum). On a cold engine, the power steering fluid level of the Skoda Octavia Tour should be between these marks. 

Minimum and maximum fluid level marks on the power steering dipstick Skoda Octavia I Tour

6. If the level on the pointer (probe) is below the MIN mark, add the required amount of working fluid. 

Topping up the working fluid in the power steering reservoir Skoda Octavia I Tour

Note:

Avoid overfilling the expansion tank with liquidThe liquid level must be kept within acceptable limits and not pour too much of it into the tank. Since the Skoda Octavia Tour power steering fluid tends to expand during engine operation, an increase in pressure can lead to problems and costly repairs.

7.  Close the power steering reservoir cap tightly by turning it clockwise.

Closing the power steering reservoir cap Skoda Octavia I Tour

8. Use a flat blade screwdriver to tighten the cover to secure. Wipe up spilled power steering fluid Skoda Octavia Tour with a clean rag.

Turning the power steering reservoir cover with a screwdriver Skoda Octavia I Tour

Note:

Be sure to use the correct power steering fluid for your vehicle, as each power steering fluid requires a different viscosity (density) to properly power the steering system.

The manufacturer does not recommend using gear oil instead of steering fluid. There is a wide variety of fluid types to choose from and choosing the wrong kind can result in steering failure and failure of steering seals.

Method for checking the cleanliness of the power steering fluid

To check the purity of the power steering fluid, it is enough to pour a few drops of fluid from the power steering reservoir onto a clean, light, non-absorbent surface. The liquid must be clean, transparent, particles of suspension should not be visible in it, the color of the liquid must be unambiguous.

There are only three colors of power steering fluid: red, yellow and green. If the color of the liquid only slightly resembles one of the listed ones, this is a reason to contact the service for checking and, if necessary, replacing the power steering fluid.

The article is missing:

  • Photo of parts and consumables
  • Tool photo

Source: carpedia.club

favorite 0
print
share
bookmark_border
None