Removal and installation of protection of the power unit (engine) Mercedes-Benz Vito W639

Tools:

• Ratchet wrench
• socket head 10 mm
• Phillips screwdriver, medium

Parts and consumables:

• Rear section of engine compartment protective tray (A 639 520 12 23)
• Front section of the engine compartment protective tray (A 639 520 11 23)
• Required fasteners for installing the guard (included) (A 003 990 53 82 and A 000 998 07 95)

Note:

Not everyone has a crankcase protection for a Mercedes Vito engine from the factory, so you need to retrofit your car with it. Included with the front protection you need tricky fasteners for quick dismantling if necessary (fastenings in the form of screws, only they are removed in half a turn). The original protection for the Mercedes Vito 639 engine is plastic. Protects the generator, starter and under-engine space from dirt and salt. It also has soundproofing properties. How power protection is ineffective.​

Front and bottom engine protection Mercedes Vito

Original engine protection

1. Drive the car into a pit or overpass.

2. Install the front part of the protective pallet of the engine compartment. It is attached with four tricky screws.

3.  Establish a back part of the protective pallet of a motor compartment. It is attached with two screws and two nuts.

1 - Fastening in the form of screws.

2 - Fastening in the form of nuts.

The article is missing:

• Tool photo

Source:  carpedia.club